|
Product Description:
- Notch, Punch, and Cut-off Die on Aluminum Plates
- Servo Drive Assembly with Alpha Gear Reducer
- Encoder bracket and Overrun Clutch
- Short Part Conveyor Belts
- Variable Speed Drive
Advantages:
- Servo accelerated Punch/Notch & Shear Die allows for close coupling with Rollformer minimizing floor space requirements
- Entry cascade with individually adjusted lead-in guide
- Entry straightener with pinch rolls
- Punching, Notching, and Shearing for variable width panel sections
- Material does not stop for Punching/Notching & Shearing, the result is greater net output of finished product
- Integrated slug capture tray (bin by customer)
- Dual timing belt, servo acceleration system
- Two operations in one acceleration move
Click to enlarge images
Standing Seam Roof Panel Line
| Material |
Pre-Painted, Galvalume, & Galvanized CRS |
| Material Strength SSR |
70,000 PSI Yield Maximum (Grade “D”)
50,000 PSI Yield Minimum (Grade “D”) |
| Material Strength Building Panel |
80,000 PSI Yield Minimum (Grade “E”)
50,000 PSI Yield Minimum (Grade “D”) |
| Thickness SSR |
.030" Maximum, .018" Minimum
22 - 26 Gauge (approximately) |
| Thickness Building Panel |
.035" Maximum, .017 Minimum
22 - 29 Gauge (approximately) |
| Rollformer Speed |
50 to 200 FPM Variable Speed |
| Mode of Operation |
Flying Prepunch/Prenotch/Precut |
| Cut Length - Precut |
42" Minimum CTL @ 100 FPM
6' Minimum CTL @ 1200 FPM
100 FPM Maximum for Punch/Notch/Cutoff |
| Length Tolerance |
+/- 1/8" @ 50' length @ 200 FPM |
Flying Hydraulic Punch / Notch Shear Technical Data
Includes shear and punch / notch units. Mounting holes and slug clearance for lead/trail hole punching included. Punch / notch and cutoff die (48" capable).
| Cutoff |
Mounted on shear bolster |
| Hydraulic System |
Dedicated hydraulic power unit |
| Panel Capacity |
48" total blade width |
| Speed |
200 FPM maximum speed – Cut Only
100 FPM maximum speed – Notch and Cut |
| Cycle Rate |
20 Cuts per minute maximum punch for Cut Only
10 cuts per minute maximum for punch / notch one end and cut |
| Cut Length without Notch |
40" Minimum, 10' (and longer) @ 200 FPM |
| Length Tolerance |
+/- 1/8" |
| Passline |
42" Nominal |
Return to Previous Page
|
|
